IEC 61300-3-35:2009

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Fibre optic connector endface visual and automated inspection

Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d'essais et de mesures - Partie 3-35: Examens et mesures - Inspection automatique et visuelle de l'extrémité des connecteurs à fibres optiques

Fecha:

2015-06-25 /Anulada

Resumen (inglés):

IEC 61300-3-35:2009 describes methods for quantitatively assessing the endface quality of a polished fibre optic connector. The information is intended for use with other standards which set requirements for allowable surface defects such as scratches, pits and debris which may affect optical performance. In general, the methods described in this standard apply to 125 ohmm cladding fibres contained within a ferrule and intended for use with sources of ≤2 W of input power. However, portions are applicable to non-ferruled connectors and other fibre types. Those portions are identified where appropriate.

Resumen (francés):

Relaciones con otras normas IEC

Es anulada por: IEC 61300-3-35:2015
Anula a: IEC PAS 61300-3-35:2002

Comprar en AENOR

Esta norma está disponible en:

Formato digital

Ingles / Bilingue